Mini Booster Drill Template
Fuzz Dog · 1590B
Template details
- Circuit
- Mini Booster
- Vendor
- Fuzz Dog
- Enclosure
- Hammond 1590B
- Dimensions
- 59.3 × 111.2 × 27 mm
- Layout
- 1590B 1-Knob (Type 1)
- Category
- Boost
Export formats
- PDF: print at 1:1 scale
- SVG: vector graphic
About this drill template
Drill template for the Fuzz Dog Mini Booster, sized for a Hammond 1590B enclosure (59.3 × 111.2 × 27 mm). The pre-positioned holes match the PCB's pot footprint exactly, with the footswitch centred below the 1-knob layout. Print at 1:1 scale, tape to the enclosure face, centre-punch, and drill. PCB and parts not included.
Fuzz Dog description: “Tremendous little booster that can do mega dB of clean or add grit if you want it.”
One board for the AMZ Mini Boost and the Bad Bob, a booster that can deliver a lot of clean level or be pushed into grit, depending on where you set the single control.
Build notes
The Hammond 1590B is the standard small DIY pedal enclosure: compact enough for a crowded board, large enough for most single-effect PCBs and a 9V battery.
Vendor specs: PCB 27 x 27mm, build difficulty easy.
Drill measurements
Hole centres for the 1590B 1-Knob (Type 1) layout. X runs left to right from the centre of the face being drilled. On the enclosure face, Y is measured from the centre, positive towards the top. For holes on a side, Y is the distance down the wall, measured from the face edge. Export the PDF for a 1:1 printable version with a scale check.
| Hole | Face | X (mm) | Y (mm) | Diameter |
|---|---|---|---|---|
| Pot | Enclosure face | 0 | 34 | 7 mm (0.28 in) |
| LED | Enclosure face | -14 | -37.6 | 5 mm (0.20 in) |
| Footswitch | Enclosure face | 0 | -37.6 | 12 mm (0.47 in) |
| DC Jack | Right side | -37.6 | 13.6 | 12 mm (0.47 in) |
| Jack | Right side | -17.6 | 13.6 | 9.5 mm (0.37 in) |
| Jack | Left side | -17.6 | 13.6 | 9.5 mm (0.37 in) |