Titan Dynamic Drive Drill Template
Aion FX · 125B
Template details
- Circuit
- Titan Dynamic Drive
- Vendor
- Aion FX
- Enclosure
- Hammond 125B
- Dimensions
- 63.6 × 119.3 × 35.8 mm
- Layout
- 125B 3-Knob 2-Toggle w/ Battery
- Category
- Overdrive
Export formats
- PDF: print at 1:1 scale
- SVG: vector graphic
About this drill template
Drill template for the Aion FX Titan Dynamic Drive, sized for a Hammond 125B enclosure (63.6 × 119.3 × 35.8 mm). The pre-positioned holes match the PCB's pot footprint exactly, with the footswitch centred below the 3-knob layout, with 2 toggles. Print at 1:1 scale, tape to the enclosure face, centre-punch, and drill. PCB and parts not included.
Aion FX description: “Based on the Fulltone® OCD™, a legendary hard-clipping overdrive pedal that makes almost any rig sound better.”
Aion FX's version of the Fulltone OCD, the hard-clipping overdrive that became a default choice for amp-like drive. The OCD's signature move is MOSFET hard clipping, which keeps the attack fast and the response touch-sensitive.
Amp-like crunch with more headroom and sparkle than a Tube Screamer style circuit; it follows pick dynamics and guitar volume changes well.
Drill measurements
Hole centres for the 125B 3-Knob 2-Toggle w/ Battery layout. X runs left to right from the centre of the face being drilled. On the enclosure face, Y is measured from the centre, positive towards the top. For holes on a side, Y is the distance down the wall, measured from the face edge. Export the PDF for a 1:1 printable version with a scale check.
| Hole | Face | X (mm) | Y (mm) | Diameter |
|---|---|---|---|---|
| Pot | Enclosure face | -16.5 | 43.4 | 7 mm (0.28 in) |
| Pot | Enclosure face | 16.5 | 43.4 | 7 mm (0.28 in) |
| Toggle | Enclosure face | -21.6 | 16.8 | 6 mm (0.24 in) |
| Pot | Enclosure face | 0 | 16.8 | 7 mm (0.28 in) |
| Toggle | Enclosure face | 21.6 | 16.8 | 6 mm (0.24 in) |
| LED bezel | Enclosure face | -19.7 | -30.5 | 8 mm (0.31 in) |
| Footswitch | Enclosure face | 0 | -30.5 | 12 mm (0.47 in) |
| Jack | Top side | -15.9 | 23.8 | 9.5 mm (0.37 in) |
| DC Jack | Top side | 0 | 23.8 | 12 mm (0.47 in) |
| Jack | Top side | 15.9 | 23.8 | 9.5 mm (0.37 in) |
Never drilled one before? How to drill a pedal enclosure walks you through the entire process, from punching the centres to the final step drill size.
Jig A covers 125B 3-Knob 2-Toggle w/ Battery
Drop it over the enclosure, punch a mark through the holes this build uses, then lift it off and drill. It wraps onto the sides too, so the jacks and DC socket are covered.
See the jig pack, $12 →