Achilles Amp Overdrive Drill Template
Aion FX · 125B
Template details
- Circuit
- Achilles Amp Overdrive
- Vendor
- Aion FX
- Enclosure
- Hammond 125B
- Dimensions
- 63.6 × 119.3 × 35.8 mm
- Layout
- 125B 3-Knob 1-Toggle (L) w/ Battery
- Category
- Overdrive
Export formats
- PDF: print at 1:1 scale
- SVG: vector graphic
About this drill template
Drill template for the Aion FX Achilles Amp Overdrive, sized for a Hammond 125B enclosure (63.6 × 119.3 × 35.8 mm). The pre-positioned holes match the PCB's pot footprint exactly, with the footswitch centred below the 3-knob layout, with 1 toggle. Print at 1:1 scale, tape to the enclosure face, centre-punch, and drill. PCB and parts not included.
Aion FX description: “Based on the Analogman Prince of Tone, a single-channel adaptation of the King of Tone, with a few added features not found in the original.”
Aion FX's take on the Analogman Prince of Tone, the single-channel version of the King of Tone. The lineage runs back to the Marshall Bluesbreaker pedal, and Aion's board adds a few options the original doesn't have.
Low-to-medium gain amp-style breakup: transparent enough to stack, covering pushed-clean through crunch.
Drill measurements
Hole centres for the 125B 3-Knob 1-Toggle (L) w/ Battery layout. X runs left to right from the centre of the face being drilled. On the enclosure face, Y is measured from the centre, positive towards the top. For holes on a side, Y is the distance down the wall, measured from the face edge. Export the PDF for a 1:1 printable version with a scale check.
| Hole | Face | X (mm) | Y (mm) | Diameter |
|---|---|---|---|---|
| Pot | Enclosure face | -16.5 | 43.4 | 7 mm (0.28 in) |
| Pot | Enclosure face | 16.5 | 43.4 | 7 mm (0.28 in) |
| Toggle | Enclosure face | -21.6 | 16.8 | 6 mm (0.24 in) |
| Pot | Enclosure face | 0 | 16.8 | 7 mm (0.28 in) |
| LED bezel | Enclosure face | -19.7 | -30.5 | 8 mm (0.31 in) |
| Footswitch | Enclosure face | 0 | -30.5 | 12 mm (0.47 in) |
| Jack | Top side | -15.9 | 23.8 | 9.5 mm (0.37 in) |
| DC Jack | Top side | 0 | 23.8 | 12 mm (0.47 in) |
| Jack | Top side | 15.9 | 23.8 | 9.5 mm (0.37 in) |
Never drilled one before? How to drill a pedal enclosure walks you through the entire process, from punching the centres to the final step drill size.
Jig A covers 125B 3-Knob 1-Toggle (L) w/ Battery
Drop it over the enclosure, punch a mark through the holes this build uses, then lift it off and drill. It wraps onto the sides too, so the jacks and DC socket are covered.
See the jig pack, $12 →