Sapphire Amp Overdrive Drill Template
Aion FX · 125B
Template details
- Circuit
- Sapphire Amp Overdrive
- Vendor
- Aion FX
- Enclosure
- Hammond 125B
- Dimensions
- 63.6 × 119.3 × 35.8 mm
- Layout
- 125B 4-Knob
- Category
- Overdrive
Export formats
- PDF: print at 1:1 scale
- SVG: vector graphic
About this drill template
Drill template for the Aion FX Sapphire Amp Overdrive, sized for a Hammond 125B enclosure (63.6 × 119.3 × 35.8 mm). The pre-positioned holes match the PCB's pot footprint exactly, with the footswitch centred below the 4-knob layout. Print at 1:1 scale, tape to the enclosure face, centre-punch, and drill. PCB and parts not included.
Aion FX description: “Based on the BOSS® BD-2 Blues Driver, one of the most popular pedals in the BOSS lineup with a drive tone resembling vintage Fender blackface amps.”
Drill measurements
Hole centres for the 125B 4-Knob layout. X runs left to right from the centre of the face being drilled. On the enclosure face, Y is measured from the centre, positive towards the top. For holes on a side, Y is the distance down the wall, measured from the face edge. Export the PDF for a 1:1 printable version with a scale check.
| Hole | Face | X (mm) | Y (mm) | Diameter |
|---|---|---|---|---|
| Pot | Enclosure face | -16.5 | 43.4 | 7 mm (0.28 in) |
| Pot | Enclosure face | 16.5 | 43.4 | 7 mm (0.28 in) |
| Pot | Enclosure face | -16.5 | 10.4 | 7 mm (0.28 in) |
| Pot | Enclosure face | 16.5 | 10.4 | 7 mm (0.28 in) |
| LED bezel | Enclosure face | -19.7 | -45.1 | 8 mm (0.31 in) |
| Footswitch | Enclosure face | 0 | -45.1 | 12 mm (0.47 in) |
| Jack | Top side | -15.9 | 23.8 | 9.5 mm (0.37 in) |
| DC Jack | Top side | 0 | 23.8 | 12 mm (0.47 in) |
| Jack | Top side | 15.9 | 23.8 | 9.5 mm (0.37 in) |
Jig A covers 125B 4-Knob
Drop it over the enclosure, punch a mark through the holes this build uses, then lift it off and drill. It wraps onto the sides too, so the jacks and DC socket are covered.
See the jig pack, $12 →