Luna Optical Tremolo Drill Template
Aion FX · 125B
Template details
- Circuit
- Luna Optical Tremolo
- Vendor
- Aion FX
- Enclosure
- Hammond 125B
- Dimensions
- 63.6 × 119.3 × 35.8 mm
- Layout
- 125B 6-Knob 2-LED w/ Battery
- Category
- Guitar effect
Export formats
- PDF: print at 1:1 scale
- SVG: vector graphic
About this drill template
Drill template for the Aion FX Luna Optical Tremolo, sized for a Hammond 125B enclosure (63.6 × 119.3 × 35.8 mm). The pre-positioned holes match the PCB's pot footprint exactly, with the footswitch centred below the 6-knob layout. Print at 1:1 scale, tape to the enclosure face, centre-punch, and drill. PCB and parts not included.
Aion FX description: “Based on the 4ms Tremulus Lune, this all-analog tremolo features six knobs for fine control over every aspect of the waveform.”
Drill measurements
Hole centres for the 125B 6-Knob 2-LED w/ Battery layout. X runs left to right from the centre of the face being drilled. On the enclosure face, Y is measured from the centre, positive towards the top. For holes on a side, Y is the distance down the wall, measured from the face edge. Export the PDF for a 1:1 printable version with a scale check.
| Hole | Face | X (mm) | Y (mm) | Diameter |
|---|---|---|---|---|
| Pot | Enclosure face | -19.7 | 43.4 | 7 mm (0.28 in) |
| Pot | Enclosure face | 0 | 43.4 | 7 mm (0.28 in) |
| Pot | Enclosure face | 19.7 | 43.4 | 7 mm (0.28 in) |
| Pot | Enclosure face | -19.7 | 10.4 | 7 mm (0.28 in) |
| Pot | Enclosure face | 0 | 10.4 | 7 mm (0.28 in) |
| Pot | Enclosure face | 19.7 | 10.4 | 7 mm (0.28 in) |
| LED bezel | Enclosure face | -19.7 | -30.5 | 8 mm (0.31 in) |
| Footswitch | Enclosure face | 0 | -30.5 | 12 mm (0.47 in) |
| LED bezel | Enclosure face | 19.7 | -30.5 | 8 mm (0.31 in) |
| Jack | Top side | -15.9 | 23.8 | 9.5 mm (0.37 in) |
| DC Jack | Top side | 0 | 23.8 | 12 mm (0.47 in) |
| Jack | Top side | 15.9 | 23.8 | 9.5 mm (0.37 in) |
Print a drill jig for your own build
The editor turns a layout into a jig for the exact enclosure you picked. It fits snugly, so it stays put while you punch and every mark lands where your layout puts it. It marks the side faces as well, so the jacks and the DC socket are covered.
See the drill jig, $29 →